• Home
• Products
• Uses
• Features
• Installation
• Place an Order
• Contact

The anchor sleeve installation process is as follows:

Requires measuring out locations for placement of anchor bolts. Once locations are marked on forms a hole is drilled through form to allow threaded end to pass through form.
A nut is placed on thread suspending anchor bolt and sleeve in void to be filled with poured concrete.
After concrete sets the nut and form are removed exposing the top of the anchor sleeve, which can be cut off and unthreaded from the anchor bolt creating a grout pocket around the anchor bolt.
The anchor bolts are then adjusted dimensionally to an accurate distance between bolts for placement of equipment or structural steel.

Once the adjustments are completed the grout pockets are filled with a non-shrinking grout. Then installation of equipment or structural steel can proceed.