Black Polyethylene Anchor Sleeves
Our anchor sleeves are molded from polyethylene giving the sleeves high strength, high working temperature, and extremely low cracking temperature. In addition, polyethylene is non-conductive providing safe use around construction sites.
The Anchor Sleeves are molded in a black color that protects them from damaging UV rays. The polyethylene is impervious to water, rusting, and corrosion of any kind.
Structural design of Anchor Sleeves
The sleeves come with a self threading neck on one end to match the thread size of your required bolt. The V-shaped ribs along the body diameter provides structural strength and increases pull out strength.
Material and Testing Data |
|
| Plastic: | High Density Polyethylene |
| Density, gms/cc: | ASTM D 1505-68 .960 |
| Vicat Softening Point °F: | ASTM D 1525-70 250°F / 120°C |
| Brittleness Temperature °F: | ASTM D 746-70 -180°F / -118°C |
| Torch Application: | Slow Burn |
| Compression Test: | 180 psi/12.7 kg/sq.cm |
Grout Volume Required |
|||||
|---|---|---|---|---|---|
| Bolt Size | Sleeve |
Sleeves per Carton | Cubic inches of Grout per Sleeve | Cubic inches of Grout per Carton | Bags of Grout per Carton |
| 1/2" | 2"x5" | 100 | 15.95 | 1595 | 1.06 |
| 3/4" | 2"x5" | 100 | 15.16 | 1516 | 1.01 |
| 5/8" | 2"x7" | 90 | 21.41 | 1927 | 1.28 |
| 3/4" | 2"x7" | 90 | 20.50 | 1845 | 1.23 |
| 7/8" | 2"x7" | 90 | 19.52 | 1757 | 1.17 |
| 1" | 3"x10" | 35 | 65.80 | 2303 | 1.54 |
| 1-1/4" | 3"x10" | 35 | 65.80 | 2303 | 1.54 |
| 1-1/2" | 4"x15" | 12 | 167.60 | 2011 | 1.34 |
| 1-3/4" | 4"x15" | 12 | 158.00 | 1896 | 1.26 |
| 2" | 4"x18" | 9 | 176.76 | 1591 | 1.06 |
| 2-1/4" | 4"X18" | 9 | 161.82 | 1456 | 0.97 |
| 2-1/2" | 6"X24" | 4 | 575.28 | 5753 | 3.84 |
| 3" | 6"X24" | 4 | 523.44 | 5235 | 3.49 |
| 4" | 6"X24" | 4 | 425.44 | 1702 | 1.13 |
| 5" | 6"X24" | 4 | 325.44 | 1302 | 0.87 |
| Note: Grout estimate based on .87 cu. ft. yield per 100 lbs. of non-corrosive grout. | |||||
Copyright ©2006 Wilson Anchor Sleeve LLC. |
September 3, 2010 |